翻訳と辞書
Words near each other
・ Raetihi
・ Raetihi Branch
・ Raetihi Forest Fire
・ Raeto Raffainer
・ Raetovari
・ Raetzer's ringlet
・ Raeville, Nebraska
・ Raevtsi
・ Raewyn Alexander
・ Raewyn Atkinson
・ Raewyn Connell
・ Raewyn Hall
・ Rae–Richardson Arctic Expedition
・ RAF (disambiguation)
・ Raf (singer)
RAF 1
・ RAF 2
・ RAF 3
・ RAF 4
・ RAF Abbots Bromley
・ RAF Abingdon
・ RAF Aboukir
・ RAF Acaster Malbis
・ RAF Acklington
・ RAF Advanced Air Striking Force
・ RAF Ahlhorn
・ RAF Air Command
・ RAF Air Defence Radar Museum
・ RAF Air Section 2
・ RAF Air Support Command


Dictionary Lists
翻訳と辞書 辞書検索 [ 開発暫定版 ]
スポンサード リンク

RAF 1 : ウィキペディア英語版
RAF 1


The RAF 1 was a British air-cooled, V-8 engine developed for aircraft use during World War I. Based on a French design it was designed by the Royal Aircraft Factory but built by six different British companies including Daimler, Rolls-Royce and Wolseley Motors Limited.
==Design and development==
The RAF 1 was based on the Renault 70/80 hp engine, being intended specifically to replace that engine in the B.E.2c. It featured larger cylinders () for a total displacement of 540 cubic inches (8.8 L). It was rated at 92 hp (70 kW) at 1,600 rpm. The heads were cast integrally with the cylinders, with the intake and exhaust valves set one above the other in an upside-down F-head configuration.
The engines featured a large diameter lightweight flywheel at the rear, enclosed in a cast housing. Engine oil was picked up from the bottom of the crankcase and slung into a reservoir at the top. From there it was gravity fed, via a gallery high on the right side of the engine block, to the main bearing caps, and then to the connecting rod journals by centrifugal effect of the turning crankshaft. The main bearings were ball bearings and were splash fed. Engine oil from the gallery was also supplied to the 1 : 2 reduction gearbox at the front. This drove the four-bladed propeller at one half engine speed, and the single camshaft was splined into the rear of the short propeller shaft. This arrangement meant that no mechanical oil pump was needed.
Excess engine oil from the flywheel overflowed the reservoir and trickled over the large surface area of the round flywheel cover. Two passages cast into the cover took air-fuel mixture from the carburettor mounted at the bottom to a copper U-shaped inlet manifold mounted between the banks of cylinders, and the flywheel cover acted as a heat exchanger, preheating the fuel-air.
In late 1915, the bore was increased to , leading to an increased displacement of 590 cubic inches (9.7 L) and power of 86 kW (115 hp) at 1,800 rpm.
〔Lumsden 2003, p. 223.〕

抄文引用元・出典: フリー百科事典『 ウィキペディア(Wikipedia)
ウィキペディアで「RAF 1」の詳細全文を読む



スポンサード リンク
翻訳と辞書 : 翻訳のためのインターネットリソース

Copyright(C) kotoba.ne.jp 1997-2016. All Rights Reserved.